Showing content from https://www.rfc-editor.org/rfc/rfc9104.xml below:
Introduction Administrative groups (commonly referred to as "colors" or "link colors") are link attributes that are advertised by link-state protocols like IS-IS , OSPFv2 , and OSPFv3 . The Border Gateway Protocol - Link State (BGP-LS) advertisement of the originally defined (non-extended) administrative groups is encoded using the Administrative Group (color) TLV 1088 as defined in . These administrative groups are defined as a fixed-length 32-bit bitmask. As networks grew and more use cases were introduced, the 32-bit length was found to be constraining, and hence extended administrative groups (EAGs) were introduced in . The EAG TLV ( ) is not a replacement for the Administrative Group (color) TLV; as explained in , both values can coexist. It is out of scope for this document to specify the behavior of the BGP-LS consumer . This document specifies an extension to BGP-LS for advertisement of the extended administrative groups. Requirements Language The key words " MUST ", " MUST NOT ", " REQUIRED ", " SHALL ", " SHALL NOT ", " SHOULD ", " SHOULD NOT ", " RECOMMENDED ", " NOT RECOMMENDED ", " MAY ", and " OPTIONAL " in this document are to be interpreted as described in BCP 14 when, and only when, they appear in all capitals, as shown here. Advertising Extended Administrative Groups in BGP-LS This document defines an extension that enables BGP-LS speakers to signal the EAG of links in a network to a BGP-LS consumer of network topology such as a centralized controller. The centralized controller can leverage this information in traffic engineering computations and other use cases. When a BGP-LS speaker is originating the topology learned via link-state routing protocols like OSPF or IS-IS, the EAG information of the links is sourced from the underlying extensions as defined in . The EAG of a link is encoded in a new Link Attribute TLV using the following format: Extended Administrative Group TLV Format 0 1 2 3 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Type | Length | +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ | Extended Administrative Group (variable) // +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ Where:
-
Type:
-
1173
-
Length:
-
variable length that represents the total length of the value field in octets. The length value MUST be a multiple of 4. If the length is not a multiple of 4, the TLV MUST be considered malformed.
-
Value:
-
one or more sets of 32-bit bitmasks that indicate the administrative groups (colors) that are enabled on the link when those specific bits are set.
IANA Considerations IANA has assigned a code point from the "BGP-LS Node Descriptor, Link Descriptor, Prefix Descriptor, and Attribute TLVs" registry as described in the following table. Code Point Description IS-IS TLV/Sub-TLV 1173 Extended Administrative Group 22/14 Manageability Considerations The new protocol extensions introduced in this document augment the existing IGP topology information that is distributed via . Procedures and protocol extensions defined in this document do not affect the BGP protocol operations and management other than as discussed in Section "Manageability Considerations" of . Specifically, the tests for malformed attributes, to perform syntactic checks as described in Section "Fault Management" of , now encompass the new BGP-LS Attribute TLV defined in this document. The semantic or content checking for the TLV specified in this document and its association with the BGP-LS Network Layer Reachability Information (NLRI) types or its BGP-LS Attribute are left to the consumer of the BGP-LS information (e.g., an application or a controller) and not to BGP itself. A consumer of the BGP-LS information retrieves this information over a BGP-LS session (refer to Sections and of ). Security Considerations The procedures and protocol extensions defined in this document do not affect the BGP security model. See the "Security Considerations" section of for a discussion of BGP security. This document only introduces a new Attribute TLV, and any syntactic error in it would result in the BGP-LS Attribute being discarded . Also, refer to and for analyses of security issues for BGP. Security considerations for acquiring and distributing BGP-LS information are discussed in . The TLV introduced in this document is used to propagate the EAG extensions defined in . It is assumed that the IGP instances originating this TLV will support any required security mechanisms for OSPF and IS-IS, in order to prevent any security issues when propagating the Sub-TLVs into BGP-LS. Security concerns for OSPF are addressed in , , and . Further security analysis for the OSPF protocol is done in . Security considerations for IS-IS are specified by . The advertisement of the link attribute information defined in this document presents no significant additional risk beyond that associated with the existing link attribute information already supported in .
RetroSearch is an open source project built by @garambo
| Open a GitHub Issue
Search and Browse the WWW like it's 1997 | Search results from DuckDuckGo
HTML:
3.2
| Encoding:
UTF-8
| Version:
0.7.4