Arduino library to support the LPS25HB 260-1260 hPa absolute digital output barometer
This sensor uses I2C or SPI to communicate. For I2C it is then required to create a TwoWire interface before accessing to the sensors:
TwoWire dev_i2c(I2C2_SDA, I2C2_SCL);
dev_i2c.begin();
For SPI it is then required to create a SPI interface before accessing to the sensors:
SPIClass dev_spi(SPI_MOSI, SPI_MISO, SPI_SCK);
dev_spi.begin();
An instance can be created and enabled when the I2C bus is used following the procedure below:
LPS25HBSensor PressTemp(&dev_i2c);
PressTemp.begin();
PressTemp.Enable();
An instance can be created and enabled when the SPI bus is used following the procedure below:
LPS25HBSensor PressTemp(&dev_spi, CS_PIN);
PressTemp.begin();
PressTemp.Enable();
The access to the sensor values is done as explained below:
Read pressure and temperature.
float pressure;
float temperature;
PressTemp.GetPressure(&pressure);
PressTemp.GetTemperature(&temperature);
You can find the source files at
https://github.com/stm32duino/LPS25HB
The LPS25HB datasheet is available at
http://www.st.com/content/st_com/en/products/mems-and-sensors/pressure-sensors/lps25hb.html
RetroSearch is an open source project built by @garambo | Open a GitHub Issue
Search and Browse the WWW like it's 1997 | Search results from DuckDuckGo
HTML:
3.2
| Encoding:
UTF-8
| Version:
0.7.4