A tool for extracting PCM encoded data from a bruteforce-sampled bitstream, primarily made for using the PCM1802 in combination with the MISRC.
Note
PCM1802 PCB & Female DuPont Cable Ribbon
For Clock/Ground SMA Male to DuPont Female.
The PCM1802 basic ADC board outputs a 78125 Hz / 24-bit stream in PCM samples.
These are 3 data lines BCK / DOUT / LRCK which go to the FPGA directly.
There is also GND which is ground and SCK which is clock input, an 22pF cap in-line is required for the PCM1802 chip to have a stable clock signal due to higher load draw of the Tang Nano 20k.
pcm_extract <BCK> <DOUT> <LRCK>
Provide the input on stdin, and the decoded audio is provided on stdout as signed 32 bit. Example usage with a MISRC capture:
misrc_extract -i test.bin -x - | pcm_extract 2 3 4 | ffmpeg -y -f s32le -ar 78125 -ac 2 -i - aux.flac
For a capture with current misrc_capture:
cat PCM1802-Audio.bin | pcm_extract 3 2 5 | ffmpeg -y -f s32le -ar 78125 -ac 2 -i - -ar 48000 MISRC_PCM1802_audio.wav
This assumes the following pin setup:
misrc_extract pads the bottom by default, so each pin number has to be offset by 2.
Up to two PCM1802s can be connected to the aux bits, and you can extract their data individually by providing the correct pin numbers to pcm_extract.
If there is no PCM data in your AUX stream the .bin file will look like the left, if there is valid it will look like on the right.
Tip
You can inspect your data files like this with any Hex editor tool (example above is just Hexedit on Linux)
RetroSearch is an open source project built by @garambo | Open a GitHub Issue
Search and Browse the WWW like it's 1997 | Search results from DuckDuckGo
HTML:
3.2
| Encoding:
UTF-8
| Version:
0.7.4